First Project for Course 22M081.

Due Feb 13 in the class.

Make two of the five regular polyhedra on Page 643.

You can use any materials:paper, board.
Commercial made models would not be accepted.
Grade will be based on accuracy. You can color them if you want.

(1) Make the one ordered on the list the same as your SS# module 5.

For example, if your SS# ends with 8 or 3, you have to make the third one
on the list on page 643. That is a Octahedron. If it ends with 0 or 5, 
then you have to make the last one on the list, which is Dodecahedron.

(2) You can make any other one for the second.

(3) Write your name on the models.

(4) Write a detailed plan about how to use a protractor to measure 
one of the dihedral angles of the non-cubic models you have made.
You cannot cut the model. 
    Measure the angle as planned.

(5) The diameter of the models should be between 1 inch and 5 inches 
    approximately.